Bumper Protector Instructions:
* Please Read Disclaimer Before Using Product

(1) Open trunk and attach strap ends to the carpet * (Fig 1) (2) Center product on rear bumper and adjust straps.
Product should always be positioned above the rear exhaust pipes. (Do not block the vehicles exhaust pipes) (3) Before driving be sure to place product inside the trunk (do not drive with product attached). With the velcro straps still attached place the product flat inside the trunk (Fig 2)

NOTE: * If Velcro does not adhere to the vehicle’s carpet, you can use the additional two velcro stickers provided. Attach velcro stickers to a clean smooth surface under the trunk carpet or another accessible area; the straps ends can then attach here. If your vehicle has a spare tire compartment in the trunk, you may drop the straps into the compartment and close the lid (Fig 3). The weight of the lid will keep the straps in place.

OPTIONAL: If the BumperBully blocks your rear license plate you may cut out the center portion using a a razor. Use the raised edge as a guide.

DISCLAIMER:
WARNING! FAILURE TO FOLLOW INSTRUCTONS MAY CAUSE SERIOUS INJURY

Caution: Never drive a vehicle with product (Bumper Bully) attached. Doing so may be dangerous. Do not block or cover vehicle's exhaust pipe. Covering the exhaust pipe can damage the product and can allow dangerous fumes to enter the vehicle - resulting in injury or death. Not for use with rear engine vehicles. Intended for parking use only. Product was designed to protect the bumpers finish only. Product may not provide protection when impacts are over 1MPH.

* Attention - Some states prohibit the covering of license plates while parked. Check with local law enforcement for applicable laws before purchasing.